烧写官方的Android系统
始终无法启动
串口打印信息直接进入boot
HELLO! BOOT0 is starting!
boot0 version : 3.0.0
dram size =1024
card boot number = 0
card no is 0
sdcard 0 line count 0
[mmc]: SD/MMC Card: 4bit, capacity: 7640MB
[mmc]: vendor: Man 0x001b534d Snr 0x7663b9fe
[mmc]: product: 00000
[mmc]: revision: 1.0
sdcard 0 init ok
The size of uboot is 0x000a0000.
sum=0xc9f92282
src_sum=0xc9f92282
Succeed in loading uboot from sdmmc flash.
Ready to disable icache.
Jump to secend Boot.
[ 0.168]
U-Boot 2011.09-rc1-dirty (Nov 08 2013 - 11:06:32) Allwinner Technology
[ 0.176]version: 1.1.0
[ 0.179]pmbus: ready
[ 0.283]PMU: AXP209
[ 0.286]PMU: AXP20x found
[ 0.289]PMU: bat ratio = 100
[ 0.292]after set, dcdc2 =1400mv
[ 0.296]PMU: dcdc2 1400
[ 0.298]PMU: pll1 912 Mhz
boot_clock = 912
dcdc2_vol = 1400
[ 0.306]after set, dcdc2 =1400mv
dcdc3_vol = 1250
ldo2_vol = 3000
ldo3_vol = 2800
ldo4_vol = 2800
power_start = 0
storage_type = -1
usb_recovery = 1
find power_sply to end
fel key old mode
run key detect
no key found
no key input
dram_para_set start
dram_para_set end
[ 0.342]DRAM: 1 GiB
relocation Offset is: 35b27000
donn\'t initialize ther user_gpio (main_key:boot_init_gpio)
DRV_DISP_Init: opened
[ 0.555]boot_disp.output_type=2
[ 0.558]boot_disp.output_mode=5
[ 0.561]boot_disp.auto_hpd=1
workmode = 0
MMC: 0
SUNXI SD/MMC: 0
mmc startup error
MMC init failed
fail to find part named env
Using default environment
In: serial
Out: serial
Err: serial
--------fastboot partitions--------
mbr not exist
base bootcmd=run setargs_mmc boot_normal
bootcmd set setargs_mmc
key 0
recovery key high 6, low 4
cant find fstbt value
no misc partition is found
to be run cmd=run setargs_mmc boot_normal
the part isn\'t exist
WORK_MODE_BOOT
WORK_MODE_BOOT
[ 1.912]Hit any key to stop autoboot: 0
cant find part named boot
sunxi_flash - sunxi_flash sub-system
Usage:
sunxi_flash read command parmeters :
parmeters 0 : addr to load(hex only)
parmeters 1 : the name of the part to be load
[parmeters 2] : the number of bytes to be load(hex only)
if [parmeters 2] not exist, the number of bytes to be load is the size of the part indecated on partemeter 1
boota: bad boot image magic, maybe not a boot.img?
sunxi#
貌似是镜像烧写的问题
偶尔能够启动内核
却无法进入系统
HELLO! BOOT0 is starting!
boot0 version : 3.0.0
dram size =1024
card boot number = 0
card no is 0
sdcard 0 line count 0
[mmc]: SD/MMC Card: 4bit, capacity: 7640MB
[mmc]: vendor: Man 0x001b534d Snr 0x7663b9fe
[mmc]: product: 00000
[mmc]: revision: 1.0
sdcard 0 init ok
The size of uboot is 0x000a0000.
sum=0xc9f92282
src_sum=0xc9f92282
Succeed in loading uboot from sdmmc flash.
Ready to disable icache.
Jump to secend Boot.
[ 0.168]
U-Boot 2011.09-rc1-dirty (Nov 08 2013 - 11:06:32) Allwinner Technology
[ 0.176]version: 1.1.0
[ 0.179]pmbus: ready
[ 0.283]PMU: AXP209
[ 0.286]PMU: AXP20x found
[ 0.289]PMU: bat ratio = 100
[ 0.292]after set, dcdc2 =1400mv
[ 0.296]PMU: dcdc2 1400
[ 0.298]PMU: pll1 912 Mhz
boot_clock = 912
dcdc2_vol = 1400
[ 0.306]after set, dcdc2 =1400mv
dcdc3_vol = 1250
ldo2_vol = 3000
ldo3_vol = 2800
ldo4_vol = 2800
power_start = 0
storage_type = -1
usb_recovery = 1
find power_sply to end
fel key old mode
run key detect
no key found
no key input
dram_para_set start
dram_para_set end
[ 0.342]DRAM: 1 GiB
relocation Offset is: 35b27000
donn\'t initialize ther user_gpio (main_key:boot_init_gpio)
DRV_DISP_Init: opened
[ 0.555]boot_disp.output_type=2
[ 0.558]boot_disp.output_mode=5
[ 0.561]boot_disp.auto_hpd=1
workmode = 0
MMC: 0
SUNXI SD/MMC: 0
Man 1b534d Snr 7663b9fe
00000
1.0
[ 1.885]sunxi flash init ok
In: serial
Out: serial
Err: serial
--------fastboot partitions--------
-total partitions:11-
-name- -start- -size-
bootloader : 1000000 1000000
env : 2000000 1000000
boot : 3000000 1000000
system : 4000000 20000000
data : 24000000 40000000
misc : 64000000 1000000
recovery : 65000000 2000000
cache : 67000000 14000000
private : 7b000000 1000000
databk : 7c000000 10000000
UDISK : 8c000000 0
-----------------------------------
base bootcmd=run setargs_mmc boot_normal
bootcmd set setargs_mmc
key 0
recovery key high 6, low 4
cant find fstbt value
to be run cmd=run setargs_mmc boot_normal
the user data\'magic is bad
WORK_MODE_BOOT
board_status_probe
sunxi_bmp_display
WORK_MODE_BOOT
[ 1.995]Hit any key to stop autoboot: 0
read boot or recovery all
[ 2.597]sunxi flash read ffset 3000000, 11618434 bytes OK
[ 2.606]ready to boot
[ 2.608]
Starting kernel ...
[ 0.647992] aw_pm_init: not support super standby.
[ 0.685898] sw_ahci sw_ahci.0: SATA power enable do not exist!!
[ 1.030021] [hdmi]hdmi module init
[ 1.035173] ##fb init:w=1280,h=720,fbmode=3
[ 1.098978] mmc0: error -110 whilst initialising SD card
[ 1.401945] init: start e2fsck listening...
[ 3.222098] init: HDMI status = 0, try 40 times!TV status = 0
[ 16.010867] init: buffer : /dev/block/mmcblk0p8
[ 16.016720] init: do_umount: /data
[ 16.020907] init: do_umount error = Invalid argument
[ 21.019183] init: buffer : /dev/block/mmcblk0p11
[ 21.025105] init: do_umount: /cache
[ 21.029141] init: do_umount error = Invalid argument
[ 21.036972] init: open device error :No such file or directory
[ 21.043694] init: open device error :No such file or directory
[ 31.011493] init: buffer : /dev/block/mmcblk0p13
[ 31.017443] init: do_umount: /databk
[ 31.021640] init: do_umount error = Invalid argument
[ 31.035207] init: cannot find \'/system/bin/sh\', disabling \'console\'
[ 31.042346] init: cannot find \'/system/bin/servicemanager\', disabling \'servicemanager\'
[ 31.051585] init: cannot find \'/system/bin/vold\', disabling \'vold\'
[ 31.058826] init: cannot find \'/system/bin/netd\', disabling \'netd\'
[ 31.065870] init: cannot find \'/system/bin/debuggerd\', disabling \'debuggerd\'
[ 31.073834] init: cannot find \'/system/bin/rild\', disabling \'ril-daemon\'
[ 31.081547] init: cannot find \'/system/bin/surfaceflinger\', disabling \'surfaceflinger\'
[ 31.090483] init: cannot find \'/system/bin/app_process\', disabling \'zygote\'
[ 31.098330] init: cannot find \'/system/bin/drmserver\', disabling \'drm\'
[ 31.105706] init: cannot find \'/system/bin/mediaserver\', disabling \'media\'
[ 31.113605] init: cannot find \'/system/bin/installd\', disabling \'installd\'
[ 31.121367] init: cannot find \'/system/etc/install-recovery.sh\', disabling \'flash_recovery\'
[ 31.130826] init: cannot find \'/system/bin/keystore\', disabling \'keystore\'
[ 31.138631] init: cannot find \'/system/bin/u3gmonitor\', disabling \'u3gmonitor\'
[ 31.146794] init: cannot find \'/system/bin/securefileserver\', disabling \'securefile\'
[ 31.155531] init: cannot find \'/system/bin/isomountmanagerservice\', disabling \'isomountmanager\'
[ 31.165336] init: cannot find \'/system/bin/gpioservice\', disabling \'gpio\'
[ 31.172993] init: cannot find \'/system/bin/systemmixservice\', disabling \'property\'
[ 31.181910] init: cannot find \'/system/bin/sh\', disabling \'console\'
[ 31.189408] android_usb: already disabled
串口打印
[ 31.189408] android_usb: already disabled
就没有任何反应了
凌乱啊。
|