Android无法启动，求指导

Daniel_wei

烧写官方的Android系统

始终无法启动

串口打印信息直接进入boot

HELLO! BOOT0 is starting!
boot0 version : 3.0.0
dram size =1024
card boot number = 0
card no is 0
sdcard 0 line count 0
[mmc]: SD/MMC Card: 4bit, capacity: 7640MB
[mmc]: vendor: Man 0x001b534d Snr 0x7663b9fe
[mmc]: product: 00000
[mmc]: revision: 1.0
sdcard 0 init ok
The size of uboot is 0x000a0000.
sum=0xc9f92282
src_sum=0xc9f92282
Succeed in loading uboot from sdmmc flash.
Ready to disable icache.
Jump to secend Boot.
[      0.168]

U-Boot 2011.09-rc1-dirty (Nov 08 2013 - 11:06:32) Allwinner Technology 

[      0.176]version: 1.1.0
[      0.179]pmbus:   ready
[      0.283]PMU: AXP209
[      0.286]PMU: AXP20x found
[      0.289]PMU: bat ratio = 100
[      0.292]after set, dcdc2 =1400mv
[      0.296]PMU: dcdc2 1400
[      0.298]PMU: pll1 912 Mhz
boot_clock = 912
dcdc2_vol = 1400
[      0.306]after set, dcdc2 =1400mv
dcdc3_vol = 1250
ldo2_vol = 3000
ldo3_vol = 2800
ldo4_vol = 2800
power_start = 0
storage_type = -1
usb_recovery = 1
find power_sply to end
fel key old mode
run key detect
no key found
no key input
dram_para_set start
dram_para_set end
[      0.342]DRAM:  1 GiB
relocation Offset is: 35b27000
donn\'t initialize ther user_gpio (main_key:boot_init_gpio)
DRV_DISP_Init: opened
[      0.555]boot_disp.output_type=2
[      0.558]boot_disp.output_mode=5
[      0.561]boot_disp.auto_hpd=1
workmode = 0
MMC:     0
SUNXI SD/MMC: 0
mmc startup error
MMC init failed
fail to find part named env
Using default environment

In:    serial
Out:   serial
Err:   serial
--------fastboot partitions--------
mbr not exist
base bootcmd=run setargs_mmc boot_normal
bootcmd set setargs_mmc
key 0
recovery key high 6, low 4
cant find fstbt value
no misc partition is found
to be run cmd=run setargs_mmc boot_normal
the part isn\'t exist
WORK_MODE_BOOT
WORK_MODE_BOOT
[      1.912]Hit any key to stop autoboot:  0 
cant find part named boot
sunxi_flash - sunxi_flash sub-system

Usage:
sunxi_flash read command parmeters : 
parmeters 0 : addr to load(hex only)
parmeters 1 : the name of the part to be load
[parmeters 2] : the number of bytes to be load(hex only)
if [parmeters 2] not exist, the number of bytes to be load is the size of the part indecated on partemeter 1
boota: bad boot image magic, maybe not a boot.img?
sunxi#

貌似是镜像烧写的问题

偶尔能够启动内核

却无法进入系统

HELLO! BOOT0 is starting!
boot0 version : 3.0.0
dram size =1024
card boot number = 0
card no is 0
sdcard 0 line count 0
[mmc]: SD/MMC Card: 4bit, capacity: 7640MB
[mmc]: vendor: Man 0x001b534d Snr 0x7663b9fe
[mmc]: product: 00000
[mmc]: revision: 1.0
sdcard 0 init ok
The size of uboot is 0x000a0000.
sum=0xc9f92282
src_sum=0xc9f92282
Succeed in loading uboot from sdmmc flash.
Ready to disable icache.
Jump to secend Boot.
[      0.168]

U-Boot 2011.09-rc1-dirty (Nov 08 2013 - 11:06:32) Allwinner Technology 

[      0.176]version: 1.1.0
[      0.179]pmbus:   ready
[      0.283]PMU: AXP209
[      0.286]PMU: AXP20x found
[      0.289]PMU: bat ratio = 100
[      0.292]after set, dcdc2 =1400mv
[      0.296]PMU: dcdc2 1400
[      0.298]PMU: pll1 912 Mhz
boot_clock = 912
dcdc2_vol = 1400
[      0.306]after set, dcdc2 =1400mv
dcdc3_vol = 1250
ldo2_vol = 3000
ldo3_vol = 2800
ldo4_vol = 2800
power_start = 0
storage_type = -1
usb_recovery = 1
find power_sply to end
fel key old mode
run key detect
no key found
no key input
dram_para_set start
dram_para_set end
[      0.342]DRAM:  1 GiB
relocation Offset is: 35b27000
donn\'t initialize ther user_gpio (main_key:boot_init_gpio)
DRV_DISP_Init: opened
[      0.555]boot_disp.output_type=2
[      0.558]boot_disp.output_mode=5
[      0.561]boot_disp.auto_hpd=1
workmode = 0
MMC:     0
SUNXI SD/MMC: 0
Man 1b534d Snr 7663b9fe
00000
1.0
[      1.885]sunxi flash init ok
In:    serial
Out:   serial
Err:   serial
--------fastboot partitions--------
-total partitions:11-
-name-        -start-       -size-      
bootloader  : 1000000       1000000     
env         : 2000000       1000000     
boot        : 3000000       1000000     
system      : 4000000       20000000    
data        : 24000000      40000000    
misc        : 64000000      1000000     
recovery    : 65000000      2000000     
cache       : 67000000      14000000    
private     : 7b000000      1000000     
databk      : 7c000000      10000000    
UDISK       : 8c000000      0           
-----------------------------------
base bootcmd=run setargs_mmc boot_normal
bootcmd set setargs_mmc
key 0
recovery key high 6, low 4
cant find fstbt value
to be run cmd=run setargs_mmc boot_normal
the user data\'magic is bad
WORK_MODE_BOOT
board_status_probe
sunxi_bmp_display
WORK_MODE_BOOT
[      1.995]Hit any key to stop autoboot:  0 
read boot or recovery all
[      2.597]sunxi flash read ffset 3000000, 11618434 bytes OK
[      2.606]ready to boot
[      2.608]
Starting kernel ...

[    0.647992] aw_pm_init: not support super standby. 
[    0.685898] sw_ahci sw_ahci.0: SATA power enable do not exist!!
[    1.030021] [hdmi]hdmi module init
[    1.035173] ##fb init:w=1280,h=720,fbmode=3
[    1.098978] mmc0: error -110 whilst initialising SD card
[    1.401945] init: start e2fsck listening...
[    3.222098] init: HDMI status = 0, try 40 times!TV status = 0
[   16.010867] init: buffer : /dev/block/mmcblk0p8
[   16.016720] init: do_umount: /data 
[   16.020907] init: do_umount error = Invalid argument
[   21.019183] init: buffer : /dev/block/mmcblk0p11
[   21.025105] init: do_umount: /cache 
[   21.029141] init: do_umount error = Invalid argument
[   21.036972] init: open device error :No such file or directory
[   21.043694] init: open device error :No such file or directory
[   31.011493] init: buffer : /dev/block/mmcblk0p13
[   31.017443] init: do_umount: /databk 
[   31.021640] init: do_umount error = Invalid argument
[   31.035207] init: cannot find \'/system/bin/sh\', disabling \'console\'
[   31.042346] init: cannot find \'/system/bin/servicemanager\', disabling \'servicemanager\'
[   31.051585] init: cannot find \'/system/bin/vold\', disabling \'vold\'
[   31.058826] init: cannot find \'/system/bin/netd\', disabling \'netd\'
[   31.065870] init: cannot find \'/system/bin/debuggerd\', disabling \'debuggerd\'
[   31.073834] init: cannot find \'/system/bin/rild\', disabling \'ril-daemon\'
[   31.081547] init: cannot find \'/system/bin/surfaceflinger\', disabling \'surfaceflinger\'
[   31.090483] init: cannot find \'/system/bin/app_process\', disabling \'zygote\'
[   31.098330] init: cannot find \'/system/bin/drmserver\', disabling \'drm\'
[   31.105706] init: cannot find \'/system/bin/mediaserver\', disabling \'media\'
[   31.113605] init: cannot find \'/system/bin/installd\', disabling \'installd\'
[   31.121367] init: cannot find \'/system/etc/install-recovery.sh\', disabling \'flash_recovery\'
[   31.130826] init: cannot find \'/system/bin/keystore\', disabling \'keystore\'
[   31.138631] init: cannot find \'/system/bin/u3gmonitor\', disabling \'u3gmonitor\'
[   31.146794] init: cannot find \'/system/bin/securefileserver\', disabling \'securefile\'
[   31.155531] init: cannot find \'/system/bin/isomountmanagerservice\', disabling \'isomountmanager\'
[   31.165336] init: cannot find \'/system/bin/gpioservice\', disabling \'gpio\'
[   31.172993] init: cannot find \'/system/bin/systemmixservice\', disabling \'property\'
[   31.181910] init: cannot find \'/system/bin/sh\', disabling \'console\'
[   31.189408] android_usb: already disabled

串口打印

[   31.189408] android_usb: already disabled

就没有任何反应了

凌乱啊。

ni_labview

没有香蕉的飘过

Soul

谁弄过